Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Terry B., 33 Blower
#1
Terry I read somewhere on the board you use a tm with a 33 blower most of the time, what size motor and are you using a heat exchanger or propane heat?

My last tm was a 33 bl with an 18 hp motor, propane heat.
The one before that was a 45bl 25 motor , I couldn't tell much of a difference in the vacuum I was getting between the two at the hose run I would use, most of the time less than 150 ft.
Reply }}
Thanks given by:
#2
I'm strongly considering one of his 33 units myself.

If I'm not mistaken he's using a heat exchanger.
I'm just trying to hack my way to glory.

Get Encapsulation Pads & More!

1 X's Orbot, Windsor & Sanitare Vacs, Multisprayer, Oreck Orbitor, Stepson, BrushEncap (TM4) CRB  
Reply }}
Thanks given by:
#3
my personal tm I use 33 blower 16 hp hx pre heat to a little giant.
Reply }}
Thanks given by:
#4
I was not planning on buying another tm, but looking at a small unit that will install in a mini van, this machine has a 33bl, 16hp motor with hx.
I have people telling me to go with a bigger machine but I think I'm going to go with the smaller machine, it worked out fine before.
Reply }}
Thanks given by:
#5
I would suggest calling Terry then. He has a lot of knowledge and can answer virtually any question.

Sent from my LG-P659 using Tapatalk
I'm just trying to hack my way to glory.

Get Encapsulation Pads & More!

1 X's Orbot, Windsor & Sanitare Vacs, Multisprayer, Oreck Orbitor, Stepson, BrushEncap (TM4) CRB  
Reply }}
Thanks given by:
#6
Video 


Reply }}
Thanks given by:
#7
That was funny. I can't believe he could say all that with a straight face. :-)
Reply }}
Thanks given by:


Forum Jump: